Samyung BNW - 50, Руководство пользователя

Страница: 32 / 64

32
6.2.1 Bracket Mounting
Before installing, consider the display unit’s weight and
search for the most convenient place for you.
Installing the display :
1) Hold the display and find the joint between the
bracket and the display.
2) Push the display gently into the bracket.
3) Turn the knob to lock.
Detaching the display :
1) Turn the unit off.
2) Loosen the knob and dismantle the end of the
bracket.
6.2.2 Flush mounting
1) Find the place to install the flush mounting.
2) Make a hole on the place you wish to install.
3) By using a saw, cut the panel
4) Make 4 holes for the screws
5) Install the screw on the display unit and put screws into the holes.
6) Attach the supplied hardware to the place you wish to install
display unit.
Before you begin, make sure you have enough space to install the display unit.
6.3 RESET SET UP ( RES1/LOW , ALARM/VIS+AUD)
Connect the reset unit (BNW-52) to the interface socket (RES1) of BNW-51, Reset unit is usually installed
near the visual alarm, however this reset unit combines the visual alarm and the 1
st stage audible alarm
together, therefore there is no need to install them separately.
Reset function should be installed near the approachable place from conning position, workstation for
navigating and maneuvering.
Also you have installation options depending on the place you wish to install the reset unit (BNW-52).
(Flush type, desk type, watertight type).
6.4 Motion Sensor
Install the dual motion sensor (DND-300M) which consists of microwave and PIR detection. Connect the
2 power supply wires to +12V and -12V. And connect one of the relay wires to the [relay] socket as
shown below. When installing the motion sensor, use the standard bracket. (Refer to chapter 8. Motion
Sensor.