English _41
●
●
Se
Tup
SC
reen
10.
Basic setting in the NAS is completed.
Connect your camera to the actual NAS.
As shown below, enter the NAS connection setting items.
11.
After entering item 10, check <
on
>.
12.
Click the [
Apply (
)
] button.
Finish saving by using the NAS.
Time schedule
You can set to save the video data at a certain interval as scheduled regardless of the actual occurrence of
the event.
1.
From the Setup menu, select the <
event ( )
> tab.
2.
Click <
Time schedule
>.
3.
Set whether or not to <
enable
>.
4.
Specify the <
Transfer interval
>.
5.
Specify the <
Activation time
>.
•
Always : Always activates in operated mode at the set
interval.
•
Only scheduled time : Periodically activates in operated
mode at a specified time and date.
J
`
The transfer interval setting value must be smaller than the preset
activation interval to succeed in image transmission.
6.
Specify the activation conditions.
•
FTP : Sets whether to enable FTP transmission when using a time schedule.
`
Refer to “
FTP / E-mail
” for more details. (page 38)
7.
When done, click [
Apply (
)
].
Tampering detection
You can set to detect tampering attempts and trigger events, such as sudden change of camera’s framing
direction, blocked lens and other overall change of scenes from the video.
1.
From the Setup menu, select the <
event ( )
> tab.
2.
Click <
Tampering detection
>.
3.
Set whether or not to <
enable
>.
4.
Set the tampering detection sensitivity. The higher the
sensitivity, detects the minutest tampering attempts.
5.
Specify the <
Activation time
>.
•
Always : To continuously check whether or not an event
has occurred. If an event is detected, a preset operation is
executed.
`
If set to <
Always
>, the activation time cannot be changed.
•
Only scheduled time : To check whether or not an event
has occurred, at a specified time on a specified date. If an
event is detected, a preset operation is executed.
•
[Clear (
)] : Reset time setting.
•
Hour : Drag your mouse at Activation Time and set the
time by hours.
•
Minute : Click an area in Activation Time and set the time
by minutes.
6.
Configure the operations to be executed when an event is
detected.
•
FTP : To set whether or not to send FTP when an event is
detected.
`
Refer to “
FTP / E-mail
” for more details. (page 38)
•
E-mail : To set whether or not to execute transmission when an event is detected.
`
Refer to “
FTP / E-mail
” for more details. (page 38)
•
Record : To set whether or not to record to a NAS or Micro SD card when an event is detected.
`
Set <
Device
> to <
On
> in <
Storage
>. (page 38)
7.
When done, click [
Apply (
)
].
J
`
The default tampering detection function may not work properly in the following cases:
-
Under circumstances of simple background or low illumination and night time may lower the detection sensitivity.
-
A severe shaking of the camera or a drastic change to the illumination can be considered a tampering by mistake.
-
Detection of the tampering may take some time (maximum 5 seconds) right after the tampering was made.
-
Once a tampering is detected, the camera will resume a normal operating after a certain stability time (approx. 5 seconds)
during which no detection will be performed.
