English _31
●
●
Se
Tup
SC
reen
viDeo & AuDio SeTup
video setup
1.
From the Setup menu, select the <
video & Audio ( )
>
tab.
2.
Click <
video setup
>.
3.
Select a <
video source
> mode.
•
Flip mode : Turn upside down the image that is captured
by the camera.
•
Mirror mode : Flip horizontal the image that is captured by
the camera.
•
Hallway view : Rotates a video that was taken from a
camera by a specified angle.
Possible to rotate 0, 90, and 270 degrees.
`
If the setting is changed, the browser window will be closed. Try to
connect again after a while.
J
`
Video output is not supported for the hallway view by SPD-100/400.
4.
Specify the privacy zone.
5.
When done, click [
Apply (
)
].
To set the privacy zone
You can specify a certain area of the camera video to be protected for your privacy.
1.
Set it to <
on
>.
2.
Click [
Apply (
)
].
3.
Click and drag the desired region on the video.
4.
Enter the name and select the color, and then click [
oK
].
5.
If you want to delete a name in the list, select it and click
[
Delete (
)
].
Audio setup (Snv-L6013r)
You can configure the input settings of the audio source from the camera.
1.
From the Setup menu, select the <
video & Audio ( )
>
tab.
2.
Click <
Audio setup
>.
3.
Set the audio input value.
•
Source : Sets the audio input.
- Line : Connect the cable to the audio device.
- External microphone : 3.5 pi(
¢
) jack type external MIC.
•
Apply power to Ext. Mic. : If the external microphone
connected has no separate power supply, check this
option to set camera to supply power to the connected external microphone. The option is enabled if
<
external microphone
> is selected.
•
Codec : Specify the audio codec.
- G.711 : A audio codec standard, it uses 64 Kbps PCM (Pulse Code Modulation) encoding.
ITU standard audio codec that is adequate for digital voice transfer in PSTN network or through a
PBX.
- G.726 : ITU standard audio codec applying ADPCM (Adaptive Differential Pulse Code Modulation) for
variable bit rates of 40/32/24/16 Kbps to 64 Kbps PCM encoding.
•
Bitrate : Set the bit rate to differentiate compression ratio if using G.726 codec.
•
Gain : Specify the audio input amplification.
J
`
Sound quality deterioration or howling may occur if the loudness of the sound source or gain value were set excessively.
4.
When done, click [
Apply (
)
].
