Samsung iDCS 500, Руководство по программированию

Страница: 187 / 533

iDCS 500 PROGRAMMING
TECHNICAL MANUAL PART 2 SEPTEMBER 2003
MMC: 501
PERI UCD REPORT 05 SEC 03-99 SEC
POWER DOWN TIME 2000 MS 1000–9000 MS
RECALL DISCONECT 002 MIN 1–250 SEC
RECALL WAIT TIME 15 SEC 000–250 SEC
ROUTE OPTIMIZE 10 SEC 0–250 SEC
SMDR START/DP 30 SEC 1–250 SEC
SMDR START/DTMF 15 SEC 1–250 SEC
SYS HOLD RECALL 45 SEC 0–250 SEC
TRANSFER RECALL 20 SEC 0–250 SEC
TSW CONN. DEL 00 SEC 00–10 SEC
UCDS AUDIO ALARM 0 SEC 0–990 SEC
UCDS VISUAL ALAM 0 SEC 0–990 SEC
VOICE DIAL DELAY 8 SEC 5–15 SEC
*Also used for wake-up calls.
TIMER DESCRIPTIONS
AA INT DGT TIME When the AA card is installed, this timer determines the
interdigit time for AA call processing. If this timer expires
before valid digits are received by the AA card, the call will
be routed to the AA invalid digits destination.
AA NO ACT TIME When the AA card is installed, this timer determines the time
that the AA card will wait for a first digit for AA call
processing. If this timer expires before a digit is received, the
call will be routed to the AA no action destination.
ALARM TIMER This is the time the system alarm key will start ringing after
the alarm key has been silenced.
ALERT TONE TIMER This timer sets the duration of the attention tone preceding a
call to a keyset in the Voice Announce or Auto Answer
mode. This tone will also precede a forced Auto Answer call.
ALM REM INTERVAL This timer controls the time length between ring attempts at
a station when alarm reminder is set. (Also used for wake-up
calls).
ALM REM RING OFF This timer controls the length of the ring cycle duration when
alarm reminder is set at a station. (Also used for wake-up
calls).
ATT RECALL TIME This is the length of time a transfer recall will ring at a station
before recalling the operator.
HELP
Table of
Contents
HOME
PAGE