Settings
Channel
Settings
Channel
ENG
Installation
Type
Tuner settings
Availalble/Restricted Services
Expected
Result
2.SatCR
2.1 Disabled status
[Tuner1 (ANT 1 IN)]
-
2 REC in same TS
-
2 REC among different TS
-
PIP
-
Zapping among different TS with 1 REC
O
O
O
O
2.2 Disabled status
[Tuner2 (ANT 2 IN)]
Not Supported (No AV)
: It will be mentioned in 1st install help description and User manual
to avoid user confusion.
Positioner
According to this option, you can disable or enable the
positioner.
You can select one of the following options:
[DiSEqC
Motor]
/
[USALS]
or disable it by selecting
[NONE]
.
Positioner Settings
If one of the
[Positioner]
types between DiSEqC motor
and USALS, additional
[Positioner Settings]
option will
appear in the
[Channel]
menu. You are able to use one
of the following options:
[User settings]
or
[Installer
settings]
.
◈
User settings
Accordingly which antenna motor type has been
selected, its configuration can be done in user
settings window.
DiSEqC Motor settings
In this window, you are able to:
-
< West : Drive West
-
East > : Drive East
-
Assign Sat. Position : Store a position
-
Go To Sat. Position : Move to the stored position
For Drive West/East two options are possible in
Motion mode.
-
[Continuous]
: If you press the button, the motor
drives until the button is released.
-
[Step]
: If you press the button, the motor drives
by several degrees only.
Each satellite has its own slot number. So after
correcting dish adjustment, you must store it as the
current position. This stored position will be used for
the dish moving during scanning or channel change.
USALS settings
In this window, you are able to set longitude and
latitude coordinates of your antenna location. Based
on this coordinates all satellites positions will be
calculated automatically. It is possible to test settings
by selecting satellite with its transponder and press
[Go To Sat. Position]
. Starting position of the dish
can be restored by pressing
[Go to Position 0]
.
35
