Settings
Channel
Settings
Channel
ENG
Positioner
According to this option, you can disable or enable the
positioner.
You can select one of the following options:
[Enabled]
or
[Disabled]
.
Positioner Settings
If the
[Positioner]
option is set to
[Enabled]
, additional
[Positioner Settings]
option will appear in the
[Channel]
menu. You are able to use one of the following options:
[User settings]
or
[Installer settings]
.
◈
Installer settings
These settings should be done while mounting the
antenna with a motor and shouldn’t be changed during
normal use. It is to set limits on the positioner motor
if the satellite dish can’t move over whole driver angle
(~180 degrees). These limits are important because if
on the way of the dish from one side you have the wall
and someone remove the limits from this side dish can
be destroyed.
In the
[Installer settings]
, you will be able to:
-
Set East limit
-
Set West limit
-
Go to initial position
-
Disable limits
◈
User settings
In the
[User settings]
Menu, you are able to:
-
Drive West
-
Drive East
-
Store Position
-
Move to Stored Position
For Drive West/East two options are possible
-
[Continuous]
: If you press the button, the motor
drives until the button is released.
-
[Step]
: If you press the button, the motor drives by
several degrees only.
Each satellite has its own slot number. So after correct
dish adjustment, you must store it as the current
position. This stored position will be used for the dish
moving during scanning or channel change.
2.
If the
[Installation type]
option is set to
[SATCR]
, additional
[Signal Cable settings]
option will appear in
[Channel]
menu.
Signal Cable settings
SatCR allows the connection up to 8 STBs via single
coaxial cable.
There are 4 and 8 slot devices available on the market.
Each device must have assigned to unique slot number
and its corresponding frequency.
Splitters must be used to connect STBs to common
coaxial cable.
SatCRs support switching between two satellites
(DiSEqC A and DiSEqC B) but only few devices have
implemented this functionality.
For 4 slot SatCR the following frequencies for devices are available on market.
-
1210 MHz
-
1420 MHz
-
1680 MHz
-
2040 MHz
For 8 slot SatCR the following frequencies for devices are available on market.
-
1284 MHz
-
1400 MHz
-
1516 MHz
-
1632 MHz
-
1748 MHz
-
1864 MHz
-
1980 MHz
-
2096 MHz
29
Содержание gx-sm550sh
Страница 92: ...Memo ...
Страница 93: ...Memo ...