10
SYSTEM ADMINISTRATOR
PROGRAMMING
CUSTOMER LEVEL ACCESS
Before any customer programs can be accessed, you must first open sys-
tem programming using the passcode you have been assigned. You must
use a display keyset. Should it become necessary to change this passcode,
see your service company.
• While on-hook, press
Transfer
and then dial
200
.
Your display shows [ENABLE CUS. PROG. PASSCODE].
• Dial the four digit passcode.
The display shows [ENABLE CUS. PROG. - DISABLE].
• Dial
1
to enable.
The display shows [ENABLE CUS. PROG - ENABLE].
• Press
Transfer
. The keyset returns to its idle condition.
• Press
Transfer
and then dial the three digit program code you want to
access. Follow the instructions for that program.
NOTE: You must begin programming within 30 seconds. Once you are in
programming, any delay of more than 30 seconds between key strokes will
cause the system to automatically close programming.
SYSTEM ADMINISTRATOR
PROGRAMMING
Home Page
System Admin
Table of Contents