Samson TROVIS 3730-1, Перевод оригинальной инструкции

Страница: 47 / 144

EB 8484-1 EN 5-13
Installation
5.6.3 Attachment to
Type 3510 Micro-flow
Valve
Î
See Fig. 5-11
Î
Required mounting parts and accesso -
ries: Table 5-7 on page 5-42.
Î
Observe travel tables on page 5-4.
The positioner is attached to the valve yoke
using a bracket.
1. Seal the signal pressure output at the
back of the positioner with the screw
plug (4, order no. 0180-1254) and the
associated O-ring (order no. 0520-
0412) if the screw plug is not yet in
place.
2. Fasten the bracket (9.1) to the stem con-
nector.
3. Screw the two bolts (9.2) to the bracket
(9.1) of the stem connector (9), place the
follower plate (3) on top and use the
screws (9.3) for fastening.
4. Mount the travel indication scale (acces-
sories) to the outer side of the yoke using
the hex screws (12.1), ensuring that the
scale is aligned with the stem connector.
5. Fasten the hex bar (11) onto the outer
side of yoke by screwing the M8 screws
(11.1) directly into the holes on the yoke.
6. Fasten the bracket (10) to the hex bar
(11) using the hex screw (10.1), shim
and tooth lock washer.
7. Mount connecting plate (6) or pressure
gauge bracket (7) with pressure gauges
10.1
1
2
1.1
1.2
6.1
6
7
8
10
9
9.1
11 11.1
3
12.1
9.2
9.3
S lever
1 Lever
1.1 Nut
1.2 Disk spring
2 Follower pin
3 Follower plate
6 Connecting plate
6.1 Seals
7 Pressure gauge bracket
8 Pressure gauge mount-
ing kit
9 Stem connector
9.1 Bracket
9.2 Bolt
9.3 Screws
10 Bracket
10.1 Screw
11 Hex bar
11.1 Screws
12.1 Screws
Fig. 5-11: Attachment to Type 3510 Micro-flow Valve