Samson Media 7 5007-1, Монтаж и эксплуатация

Страница: 114 / 124

16-12 EB 9510 EN
Annex A (configuration instructions)
Menu Adjustment range/values/description
4 to 20 mA measured
value
2.4.x.32
Reading of the current (in mA) at the option module
Relative measured value 2.4.x.33 Reading of the current (in %) at the option module
Start test 2.4.x.34 Executable function: two-wire test signal issued.
Test mode 2.4.x.35 Test mode is Active while the test is in progress (test duration:
30 s).
▪ Not active
▪ Active
Analog input test signal 2.4.x.37 Test signals (depending on the selected unit) based on the 4 to
20 mA signal range.
Zero point 2.4.x.38 This parameter allows a zero calibration to be performed for
the measured value of the option module's analog input.
The zero calibration must always be performed before the
span calibration.
'Set zero' sets zero to 0 %.
The following values are displayed under the 'Set zero'
function:
1. Measured value of the analog input in %
2. Currently adjusted zero in %
3. Measured value of the analog input in mA
Span 2.4.x.39 This parameter allows a span correction to be performed for
the measured value of the option module's analog input.
The zero calibration must always be performed before the
span correction.
'Set span' sets the span to 0 %.
The following values are displayed under the 'Set span'
function:
1. Measured value of the analog input in %
2. Currently adjusted span in %
3. Measured value of the analog input in mA
A span correction is not taken into account in the test mode.
Zero shift 2.4.x.40 Zero shift reading in %
Span offset 2.4.x.41 Span offset reading in %
Identification 2.5
Firmware version 2.5.1 Reading of the current firmware version of the Media 7 device
Serial number of the
entire device
2.5.2 Reading of the serial number of the Media 7 device