Samson Media 7 5007-1, Монтаж и эксплуатация

Страница: 42 / 124

5-6 EB 9510 EN
Installation
5.3.2 Inserting the GSM
module
The GSM module does not function when the
differential pressure meter is operated with
the standby power supply (SPS).
When the differential pressure meter was or -
dered with the GSM module, it is already in-
stalled upon delivery. The GSM module can
also be retrofitted (see Fig. 5-3).
The GSM module unit consists of the module
(including SIM card) and the right-angle an-
tenna with cable and SMA bushing.
Mounting the cable and antenna
1. Remove the stopper in the housing (1).
2. Place the O-ring (5) on the SMA bushing
(6) and push it into the groove intended
for it.
3. Guide the SMA bushing (6) with O-ring
(5) from inside through the hole in the
housing (1) and push it as far as it will
go.
4. Place the toothed lock washer (4) on the
SMA bushing (6).
5. Place the nut (3) on the SMA bushing (6)
and screw tight.
6. Screw the antenna (2) onto the SMA
bushing.
Inserting the GSM module
1. Insert the male connector (7) into the fe-
male connector (8) on the module.
2. Insert the module into the slot as shown
in the diagram.
3. Tighten the two fastening screws (9) of
the module.
Note