SAMES KREMLIN
- 7 -
N° 578.209.110-UK-1907
DISASSEMBLY / REASSEMBLY OF THE SUCTION SECTION SUB-ASSEMBLY (A)
Nota : The disassembling of the upper tightness seal and of the bellows requires to separate
the fluid sub-assembly (B) from the suction sub-assembly (A).
SEPARATION PROCEDURE
Disassemble the cylinder (32). You can see the fluid
section (29).
You must place the piston downwards.
Install an air pressure (from 0.2 to 0.5 bar / from
2.9 to 7.2 psi) on the air motor. When the piston is at
its lower point, close the air inlet valve to prevent the
piston from getting up.
Remove the 3 nuts (22), the washers (21).
Pull the suction flange (20) downwards, you can see
the skirt (10).
Nota: The cylinder (17) must keep assemble with the
suction bearing (11).
Unscrew slightly 3 screws (15).
Unscrew the skirt (10) (tools : with a 36mm wrench).
Nota : To make easier the disassembly of the skirt,
you can remove one of the 3 pump tie-rods (19).
Slide up the skirt-bellows set to clear the access to
the flat on the coupling rod (8).
Caution : the skirt must be visible.
By means of 2 wrenches, to separate the piston (29)
from the coupling rod (8) by using the flats on the
coupling rod and those on the base of the piston.
