SAMES KREMLIN
- 6 -
N° : 578.087.120-UK-1907
ADJUSTMENT
Guards (air motor cover, coupling shields, housings …) have been designed for safe use
of the equipment.
The manufacturer will not be held responsible for bodily injury or failure and / or damage
to property due to removal or partial removal of the guards
Before starting the equipment, (see the Installation section view).
Follow these instructions :
- Put the rod in a product, solvent or other drum,
- The main air valve (A) is closed,
- Close the depressurize valve (D),
- Close the drain valve (H),
- Adjust the air regulator (C) on ‘O’,
- Lock the fluid regulator (J),
- Open partially the drain valve (H), place a drum to get the drained material,
- Open the air valve (A),
- Open the depressurize air valve (D),
- Adjust the air regulator (C) to operate slowly the pump (
≤ 8 cycles / mn)
,
- Operate to get off air from the pump,
- Close the drain valve (H),
- Open the fluid regulator (J),
- Adjust the fluid regulator (J) to operate slowly the pump between 8 an 10 cycles / mn)
- Fill the T lubricant* into the cup until it reaches the maximum level,
Nota : if necessary, in the first few rounds, while the piston goes up, drive out the air
contained in the pump by opening manually the valve of the cup (M).
- Refill with the T lubricant* until the backflow into the cup (
≃
1.2L / 0.32 US gal).
* Use only SAMES KREMLIN T lubricant
Then adjust :
- air pressure to the regulator (C),
- fluid pressure to the regulator (J).
Depending upon :
- material viscosity,
- material hoses' length and diameter (K),
- work.
Nota : Before starting the work, check that the working range is correct.
