Sirius 800 Series User Manual
Default Serial Port Configuration:
External Control 7.3
Iss 5 Rev 7
Page 86
© 2017 SAM
7.3 Default Serial Port Configuration:
When the sample/default database is loaded on the router control module(s) the four RS485
serial communications ports on the rear of the router (see section 16) are configured as
shown in Table 14
If a custom database is loaded on the router control module(s) the ports may be configured
differently. Port configuration can be checked and modified using the Workbench software,
see the Workbench User Manual for details.
•
RS485 1 (COM 3)
= General Switcher In (SW-P-02) for Centra or Aurora control
•
RS485 2 (COM 4)
= General Switcher In (SW-P-02) for Centra or Aurora control
•
RS485 3 (COM 5)
= Panel Protocol for up to 16 controllers on addresses 1 to 16 as
shown in the table below:
•
RS485 4 (COM 6)
= General Switcher In (SW-P-02) for Centra or Aurora control
“Auto” mode has been configured in the default database as the primary reference source for
all inputs (see section 3.11 for information on video and audio reference inputs).
Address
Controller
Sources
Destinations
1
Dial-up X-Y panel
All
All
2
Dial-up Multibus (8 Bus) panel
All
1 to 8
3
Dial-up Multibus (6 Bus) panel
All
1 to 6
4
Dial-up Multibus (4 Bus) panel
All
1 to 4
5
Dial-up Multibus (2 Bus) panel
All
1 and 2
6
16 x 1 BPX panel
1 to 16
1
7
32 x 1 BPX panel
1 to 32
2
8
48 x 1 BPX panel
1 to 48
3
9
Dual 16 x 1 BPX panel
1 to 16
1 and 2
10
16 x 4 X-Y panel
1 to 16
1 to 4
11
32 x 4 X-Y panel
1 to 32
1 to 4
12
48 x 4 X-Y panel
1 to 48
1 to 4
13
32 x 16 X-Y panel
1 to 32
1 to 16
14
24 x 12 X-Y panel
1 to 24
1 to 12
15
Not Used
16
16 x 16 X-Y panel
1 to 16
1 to 16
Table 14
Controllers and Addresses in the Default Database
