Tel: 886.2.2175 2930 Email: [email protected]
64
5.7.3
Save/Load Setup
Save Setup
The oscilloscope software saves the current setup before you close the oscilloscope software. The oscilloscope
recalls this setup when you run the software next time. You can use the “File->Setups->Save Setups” in main menu
to permanently save setting.
Load Setup
The oscilloscope can recall the last setup before the oscilloscope software was running, any saved setups, or the
factory setup. You can use the “File->Setups->Load Setups” in main menu to permanently recall setup.
5.8
Display System
Please refer to
5.9
Measure Signal
5.9.1
Cursor
Click “Cursor” in main menu. More information, please refer to
Please slid the slider to enable or unable the cursor function.
1)
Source
The user can set the source to CH1, CH2, MATH and FFT.
2)
Type
There are two types of cursors: Cross and Trace.
The Cross cursor display window:
