Tel: 886.2.2175 2930 Email: [email protected]
29
Readout shows the coupling of the channels.
Readout shows the vertical scale factors of the channels.
A “B” icon indicates that the channel is bandwidth.
12)
Status Information.
Demo: Don’t communicate with PC.
Disconnected: The device is not connected with PC successfully.
Connected: The device is connected with PC successfully.
13)
Trigger Level.
14)
The marker shows the reference points of the displayed waveforms.
If there is no marker, the channel is not displayed.
15)
The same as 14.
16)
Displays the trigger information
Display the edge trigger slope, source and level.
17)
Marker shows horizontal trigger position.
18)
Trigger status indicates the following.
Auto: The oscilloscope is in auto mode and is acquiring waveform in the absence of triggers.
Trig’D: The oscilloscope has seen a trigger and is acquiring the post trigger data.
WAIT: All pretrigger data has been acquired and the oscilloscope is ready to accept a trigger.
Stop: The oscilloscope has stopped acquiring waveform data.
Run: The oscilloscope is running.
Play: The oscilloscope is displaying the record waveform.
4.5
The Menu System
The Main Menu:
1)
File: Load or save CSV, waveform and setup
2)
View: Change the user interface
3)
Setup: Set Horizontal, vertical, trigger system.
4)
Display: Change wave display type, intensity and color.
5)
Cursor: Set cursor measure source and measure type
6)
Measure: Set measurement source and measure parameters.
7)
Acquire: Start, Stop, Autoset and other operation setting
8)
Utility: Utility setting, record waveform, pass/fail test, self calibration, factory setup and language setting.
9)
Help: Turn on help file.
