Tel: 886.2.2175 2930 Email: [email protected]
30
4.6
Setup the Oscilloscope
Use “AUTOSET” to display a signal automatically.
Auto setup functions one time each time you click the “AUTO” button. The function obtains a stable waveform display
for you. It automatically adjusts the vertical scale, horizontal scale and trigger settings. Auto setup also displays
several automatic measurements in the graticule area, depending on the signal type.
Connect a signal to the CH1 input:
1)
Connect a signal to the oscilloscope as described above.
2)
Click the “Acquire ->Autoset” button.
The oscilloscope will change the current settings to display this signal.
Save Setup
The oscilloscope software saves the current setup before you close the oscilloscope software. The oscilloscope
recalls this setup when you run the software next time. You can use the “File->Save Setup” in main menu to
permanently save setting.
Load Setup
The oscilloscope can recall the last setup before the oscilloscope software was running, any saved setups, or the
factory setup. You can use the “File->Load Setup” in main menu to permanently recall setup.
Factory Setup
The oscilloscope software is set up for normal operation when it is shipped from the factory. This is the factory setup.
Click the “Utility->Factory Setup” in main menu to recall this setup.
4.7
Set Horizontal System
4.7.1
Horizontal Setting
Click “Setup->Horizontal” menu.
The following figure shows the Horizontal System window. It shows the horizontal parameters settings.
