Salter Brecknell LPS-400, Руководство по эксплуатации

Страница: 16 / 18

4.
Ad
_ _ _
--------- ADC is below min. range;
5. ¯ ¯ ¯ ¯ ¯
---------- weight signal is too large
6.
_ _ _ _ _
------- weight signal is too small
7.
EEP.E0
-------- the EEPROM can’t be accessed;
8. EEP.E1
---------The parameters are not same with backup data;
9.
EEP.E2
---------The setting parameter(s) is not in normal range;.
10.
CAL-Px
--------scale’s calibration point;
11. CAL.Er
---------there is an error in calibration
12.
X
Hold
----------hold function is active.
13.
Net
◄ ----------- The display reading is net weight
14. Zero
◄ ----------The scale is at zero point
15.
CAP.-- -----------The the setting full capacity will be displayed
16.
d.-- -----------The division will be displayed
17.
Px.y ----------- The No. x parameter is set to y.
18.
Lo.bAt ----------The voltage of batteries or input power is below 4.7V
========================================================
Ⅸ
. The direction of indicator with bracket
The display is supplied with ABS plastic bracket, wall mounting vertically or
bench mounting horizontally to read the weight display as following drawings.
(1) Placed vertically (2) Placed horizontally
25
Ⅹ
.Key Definition summary:
KEY MODE DEFINITION
Normal weighing mode
Enter or exit HOLD mode; output the
data as per P4,P5,P6 setting
Setup mode/Calibration
mode
Shift the flashed position from right to
left HOLD
/PRINT
Displaying A/D code or
input voltage mode
No Function
Normal weighing mode
Choose weight units, refer P8, P9,
P10, P11 setting and Table3,Table4.
Setup mode/Calibration
mode
Change the digit on flashed position
and click this button to add 1.
UNIT
Displaying A/D code or
input voltage mode
Choose the weight inner code or input
working voltage to be displayed.
Normal weighing mode Tare the weight
Setup mode/Calibration
mode
Confirm the displayed parameters or
input data, and go to next step
TARE
Displaying A/D code or
input voltage mode
Choose filtered or un-filtered weight
A/D data
Normal weighing mode Zero function or Power off the scale.
ON/OFF/
ZERO
Setup mode/Calibration
mode/Displaying A/D code
or input voltage mode
Exit and back to normal work mode
ON/OFF/
ZERO
+
HOLD
/PRINT
Normal weighing mode
(more than 3s)
Go to Show A/D code or input
working voltage of indicator mode
26