Assemble and
Attach Tabletop
1.
Place the tabletop (
A
) on the floor with the
top side down on a soft surface to avoid
scratching it. The belt slot of the tabletop
should be to your right. With the back of
the legs facing you, place them on top
of the tabletop and line up the back pilot
holes in the table with the leg mount holes.
Loosely thread a hex head lag screw (
B
),
lock washer (
C
), and large flat washer (
D
)
into each back pilot hole first. Then align
the front leg holes to their corresponding
tabletop pilot holes and thread in their
screws, lock washers, and flat washers (
8
).
2.
Use a 3/8 inch socket wrench to tightly
drive all four of the hex head lag screws
(
B
), lock washers (
C
) and large flat
washers (
D
) into the tabletop.
3.
The legs have adjustable feet. Rotate the
locking nut in a manner allowing each foot
to be threaded all the way in (
9
). Once
the table is upright this makes it easier to
adjust one or two feet to stabilize the table.
Once adjusted, use the nut to lock the
position permanently.
Attach Idler Pulley
1.
Partially thread the two remaining hex head
lag screws (
B
), lock washers (
C
) with two
small washers (
E
) into the two pilot holes
next to the belt slot of the tabletop (
10
).
2.
Slide the two parallel slots of the Idler Pulley
L-bracket (
F
) under the washers (
E
) so that
the wheel portion is facing the belt slot of
the tabletop. Tighten the lag screws (
B
) with
a 3/8 inch socket wrench. Position the lag
screws within the slots as shown (
11
).
3.
Flip the table structure on its feet and
tighten all the bolts on the treadle with a #2
Phillips screwdriver and tighten the bolts on
the legs with a 14mm socket wrench, while
ensuring the upright legs are vertical.
8
9
10
11
Hardware is scaled 50%
C
A
F
2-1/2"
D
B
B
C
E
Hardware is scaled 50%
Stitch Master
®
Guidebook: Assembling the Stitch Master
10
9
