3.
To attach the treadle to the bottom brace,
flip the treadle upside down with the treadle-
bracket facing the back leg brace. Line up
the holes on the sides of the treadle with the
pivots and slide the pivots into the treadle.
Center the treadle with the stand and tighten
the pivots (
7
). The treadle must be able to
pivot freely without left and right play.
Assemble and
Attach Treadle
1.
Hold the treadle (
A
) so that the bolt holes
are facing toward you with the rubber pad
up. Next, place the treadle-bracket (
B
) over
the two right-most holes and thread the two
bolts (
C
) through each hole. Position the
bolts all the way to the left in the treadle-
bracket slots and tighten each bolt (
C
) with
a nut (
D
) on the back side (
5
).
2.
Find the two pivots (
E
), bolts, lock washers
and washers (
F
) and nuts (
G
). With
the stand upside down, place one pivot
underneath the far right slot of the bottom
brace making sure the tab is facing up,
away from center and through the slot. Run
the bolt up through the hole in pivot (
E
)
from underneath the bottom brace, then
place the nut on top and loosely thread
together (
6
). Repeat this step with the other
pivot on the furthest opposite hole of the
bottom brace making sure the tab on the
pivot is facing up away from center.
5
6
7
Hardware is scaled 50%
Tabs
E
F
G
A
B
C
D
Stitch Master
®
Guidebook: Assembling the Stitch Master
8
7
