3.
Flip the legs upside down and lay the
bottom brace (
D
) into the desired position
across the bottom of the legs. This will
determine the distance the treadle will
be from the operator once seated. We
recommend installing it 3-1/2 inches from
the front end of the legs (
3
). Find two
more bolts, lock washers and washers
(
C
) and rectangular nuts (
E
). Slide the
rectangular nut (
E
) into position inside the
leg cavity. The washer should bridge the
open channel cavity. While holding the
rectangular nut in the desired position,
slide the bottom brace into position and
thread in the corresponding bolt (
4
). Do
this for both sides.
4.
Use a tape measure to confirm the
bottom brace is squarely positioned.
Tighten the bolts.
Assembling the Legs
1.
Position legs (
A
) on their side, unfinished
sides facing in, with the feet facing you.
Line up the back brace (
B
) with the
corresponding threaded holes (
1
).
2.
To connect the back brace, find parts (
C
)
and loosely thread them through each
of the four holes (
2
). Use a #2 Phillips
screwdriver to make these snug but do not
tighten completely.
Hardware is scaled 50%
1
2
C
C
E
3
4
Hardware is scaled 50%
A
D
B
Stitch Master
®
Guidebook: Assembling the Stitch Master
6
5
