Configuration of Tones
114 TELSAT
GPRS
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
17 Configuration of Tones
Tones generated by the TELSAT GPRS can be configured by editing the parameter file
tone.ini
. You can access this file in the same way as the parameter file
para.ini.
Refer
to page 84.
TONES
In the section TONES The frequencies of all available slic
generated tones can be defined. Entering invalid values will
provoke the default settings. You can define the following tones:
Phone port
default
[Hz]
Phone/Fax/Modem port
default
[Hz]
Dial
tone
CHA_DIAL_TONE 440 CHB_DIAL_TONE 440
Ring back tone CHA_CALL_CTRL
440
CHB_CALL_CTRL
440
Busy
tone
CHA_BUSY_TONE 440 CHB_BUSY_TONE 440
Call wait tone CHA_CALL_WAIT
440
CHB_CALL_WAIT
440
Programming
acceptance tone
CHA_ACPT_PROG 950 CHB_ACPT_PROG 950
Programming non-
acceptance tone
CHA_NACPT_PROG 300 CHB_NACPT_PROG 300
PIN last try tone CHA_PIN_LAST
600
CHA_PIN_LAST
600
SIM missing tone CHA_SIM_MISS
950
CHB_SIM_MISS
950
Available frequencies are in the range from 300Hz up to 1500Hz in steps of 5Hz.
Example:
CHA_DIAL_TONE=440 sets the frequency for the dial tone of channel A to
440 Hz
TONE_LEVEL
In the section TONE_LEVELS, the gain of the generated tones on
the SLIC ports can be defined. Following parameters are available
in this section for the tone gain on channel a and b.
Phone port
default
[dB]
Phone/Fax/Modem port
default
[dB]
Level
CHA_TONE_LEVEL 0
CHB_TONE_LEVEL 0
Available gains are in range from 0dB down to –30dB in steps of 1dB.
Example:
CHA_TONE_LEVEL=0 sets the gain to 0dB for channel A