Putting the device into operation
12 TELSAT
GPRS
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
3.4
Enter the PIN number
Before you can use the TELSAT GPRS, enter the PIN (Personal Identification Number).
You will receive the PIN number with the SIM card from your network provider.
!
If you have received a TELSAT GPRS with Autopin function read chapter 3.5
before going on.
To enter the PIN use a telephone set connected to the
Phone
port or the
Fax/Modem/Phone
port of the TELSAT GPRS. Use the telephone to enter the PIN (by
sending DTMF codes to the TELSAT GPRS) just as you would dial a number:
When you pick up the handset (go off hook), you will hear a recurrent short beep tone,
that prompts for the PIN. Enter the PIN as shown below, then hang up (place the
handset on hook).
To enter the PIN:
*8
PPPP
It means:
PPPP
Please enter your PIN number here .
Allowed PIN numbers are 0000 to 99999.
means: listen to the confirmation tone:
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong PIN
You may have to wait 3 seconds before hearing the confirmation tone.
means lift up the handset
means hook on the handset
If you have entered the wrong PIN, the
LED will flash rapidly. In this case, try
it once more. If you have entered two times the wrong PIN, you have only one more try
to enter the PIN before the SIM card is locked (see chapter 3.6). This last try is
indicated by a special beep tone.
