Safegate Group safedock, Руководство пользователя

Страница: 64 / 348

SAFEDOCK®

Safegate Group
Manual Date: 6 February 2015
Chapter: 2A Operator Panel Softkey Setup Version: 2.7
Page 6 of 8
Note : Com1 Test can only be performed when the Safedock software is not running
as Safedock data interferes with the test. A connection to the Loader using SMT is
required before starting this test.
3.6.3 Com2 Test (not in use)
Note : Com2 test is not currently in use or supported by software.
3.6.4 Output Test
Connect a cable specifically designed for testing the outputs to connector J9 to test
outputs 1-6. Connect the cable to J10 for test of outputs 7-11. Use the
+ / - keys to
select the output and then the On / Off keys to toggle the current output.
To test output 12 (Maintenance relay), using an ohm-meter connected to J1 pin 3 and
J3 pin 1. Toggle the output and verify that the ohm-meter indicates this.
The status of output 13 (heater) is indicated by LED D17 on the circuit board. Toggle
the output and verify that the LED is lit only when the output is active.
3.6.5 Input Test
The input test is automatically enabled. Whenever a change is detected on the inputs
the display shows the current status of all inputs.
To test the inputs, connect to the outputs with a specific cable design. To test inputs 0
to 7, connect the cable between J9 and J8. This makes outputs 1-5 control inputs 0-4
and output 6 controls all three inputs 5, 6 and 7.
Connect the cable between J9 and J7 to test inputs 8
– 15. This makes outputs 1-5
control inputs 8-12 and output 6 controls input 13, 14 and 15.
3.6.6 Display Test
If selected, a pattern appears in the display.
3.6.7 Temperature Sensor
When entering the test functions menu the temperature measurement from a sensor
appears on the display, for example
Temp: 26 . To test this sensor, chill IC11 and
check the temperature value in the display falls.