Safegate Group safedock, Руководство пользователя

Страница: 181 / 348

SAFEDOCK®

Safegate Group
Manual Date: 6 February 2015
Chapter: 4 MAINTENANCE Version: 2.7
Page 47 of 52
(e) On the Operator Panel front, lift up a corner of the film
using a knife.
(f) Carefully start to cut at the film (bottom layer)
adhesive and simultaneously detach the film.
Note : The film is layered, be careful not to split the
layers when cutting/detaching it. When approximately
half of the film is released from the surface, it may be
possible to detach the rest of the film, without cutting.
(g) During removal of the film, pull the film cable out
through the upper hole in the cover.
Clean the exposed front cover metal surface
thoroughly with white spirits on a cleaning cloth until
all remaining adhesive is removed.
FIGURE 4.58
– OP FILM REMOVAL
Renewal
FIGURE 4.59
– OP FILM RENEWED
(a) Remove all protective coverings from the new film to
expose the adhesive surface.
(b) Carefully feed the film cable through the exposed
upper hole in the front cover.
(c) Carefully place the upper area of the film according to
the contours for the film on the cover surface.
(d) Slowly even out from the top of the film downwards,
making sure no air bubbles exist. Continue until the
entire film is in place at the bottom.
(e) Wipe over the film surface with a dry clean cloth.
Note : If the new film does not have a pre-cut
Emergency-Stop button hole, locate the approximate
centre of the hole by pressing on the film, or use the
old film as a template to find it.
Make neat incisions (horizontal, vertical and diagonal)
with a knife from the centre of the hole to the contour
to create sections to cut away. Carefully cut away the
sections to expose the hole.
(f) Place the Emergency-Stop button in position.
(g) Whilst holding the Emergency-Stop button in position,
open the front cover and clamp the Emergency-Stop
button terminal in the place on the inside.
Fasten the terminal with the screw.
(h) Connect the film and Maintenance connectors to the
circuit board on the inside of the cover.
(i) Close the cover and secure the screws.
(j)
Pilot Display : Locate the lower DIN rail and set the
power switch set to ON .
Testing
(a) Verify the system starts up correctly: Operator Panel contact is re-established and the Emergency-
Stop button function is operational.
Note : For more information, see Chapter 3 OPERATION.
(e)