Safegate Group safedock, Руководство пользователя

Страница: 180 / 348

SAFEDOCK®

Safegate Group
Manual Date: 6 February 2015
Chapter: 4 MAINTENANCE Version: 2.7
Page 46 of 52
6.9 RENEWAL OF OPERATOR PANEL FILM (SOFTKEY)
Renewal of Operator Panel Film (Softkey)
This information is a basic step by step guide for authorized personnel to replace an old type, a
damaged or worn film on the front cover, with a new one.
Before you start
WARNING : DANGER OF ELECTRIC SHOCK!
(a) ISOLATE THE POWER SUPPLY PRIOR TO UNDERTAKING ANY MAINTENANCE!
(b) IF A BATTERY BACKUP IS INSTALLED, THE 24 VOLT DC CURRENT TO ELECTRONICS
MUST ALSO BE SWTICHED OFF.
Note : Tools required are No. 1, 2 Phillips and flat blade screwdrivers, a knife, white spirits and a
cleaning cloth.
Removal
FIGURE 4.56
–OP FILM
(a) Pilot Display : Locate the power switch on the lower
DIN rail and set to OFF .
(b) Operator Panel : Loosen the screws of the cover and
open it.
(c) Disconnect the film cable and maintenance cable
connectors from the circuit board inside the Operator
Panel.
(d) Disconnect the Emergency-Stop button and cabling
from the inside of the cover as follows:

Loosen the terminal screw.

Release the terminal clamp.

Pull the Emergency-Stop button away from the
cover
.
Note : Keep the Emergency-Stop button and terminal
screw in a safe place until the film is replaced.
FIGURE 4.57
– OP FILM CONNECTION
(b) (b)
(b)
(b)
(d)
(c)