Car lift installation, operation and maintenance manual Type
：
4SF-4000B
15
B
：
Leveling of safety
Hold the unloading handle of the power unit, lift down, until the fall to insurance work state, the wire rope is slack at the moment, measuring the
2 end of the beam to the main side column base plate distance is equal, if not equal, adjust the top of the column insurance nut until the 2 beam
four end the bottom plate distance line.
Step21
：
Install the expansion bolts
：
1.
Use electric hammer drill to swell the bolt mounting hole
，
energize vertically
，
do not allow the drill to tilt.
2.
Drill through the hole and sweep away the dust
，
Make sure that the bottom plate is aligned with the line to be drawn during drilling.
3.
If the plate requires gaskets to ensure the level, plug the appropriate quantity of the gasket so that the expansion bolt is tightened and the
column and the ground are vertical. Plug in the gasket and start tightening the expansion bolts.
4.
Install the sub column in accordance with steps 1,2,3.
Drill hole Dust removal knock expansion pin Wrench tightening
Attention
：
1.The above steps are all the installation steps of the four post car lift
，
2.SAFE is committed to continuously improve product quality, update technical specifications, subject to change without notice.
3.4 Check the items after installation
1
、
The upright post is perpendicular to the ground 2
、
Tubing connections are in place 3
、
The wire rope is connected in place
4
、
The main and auxiliary lifting bridge installed in place 5
、
The electrical connection is correct 6
、
Fastening of other parts
7
、
The part that needs lubrication is lubricated
