Car lift installation, operation and maintenance manual Type
：
4SF-4000B
10
A:4048 B:2722 C:5267.2 D:4947.5
Step 7
：
Using the lifting device to position the large parts of lifting machine according to the position below
：
7.1,For easy installation, use the “Block the tire bracket ”to pad the beams.
7.2,Pull the wire rope out of the main bridge plate and put the wire rope pass the main vice beam rope wheel.
A
：
The main and sub slab bridge has been installed before the factory, including cylinder connection, wire rope connection and tubing connection.
B
：
The main and secondary beam is installed before the factory, including the connection of the unlocking device, the connection of the main
safety, the connection of the cable break safety and the connection of the rope wheel.
Step 8
：
The main secondary beam is connected with the main and sub slab bridge,dashboard will connect with the main and sub slab
bridge, as shown below:
8.1,Using the M12*25 outer hexagonal bolts, flat washers, spring washers to connect the main secondary beam and the main sub slab bridge
8.2,Using M12*16 outer hexagonal bolts, flat washers, spring washers to connect the dashboard and the main sub slab bridge
Tyre retaining bracket
