23
Function (M3/M4) Reciprocating Movement
M3/M4:
With this function enabled by pressing the
command pedal (a) or the button (b) at the
own handpiece, the motor will spin propelling
the instrument in a cutting direction (reverse
spinning) and afterwards the movement is
inverted to release the instrument (forward
spinning).
a
b
M4
“DENTSPLY”
standard
RECIPROC
350
M3
“VDW”
standard
RECIPROC
300
Programming of the Operative Sequence (M2)
The Endus Duo R micromotor allows the programming of up to 9 stages for the rotatory
instrumentation on the M2 mode.
- Press the MODE key to select the operacional mode and PROGRAM to choose between one of the
pre-defined programmings, which will be saved for the other modes.
To adjust the values choose the M2 mode.
The torque value and the number of the programming will blink one after the other, press SET to
select the next option and, at this moment press the “” key or the “ADJUST-“ to choose
the desired value. Three (3) seconds after the last key has been pressed, the numeric value will be
saved. Then, press the SET key again to confirm the numeric value to be saved or to edit a new value.
Pressing the REVERSE key the micromotor retrocedes, spinning on the counterclockwise direction.
EQUIPMENT OPERATION
Reverse spinning
Forward spinning
