19
08
09
10
Counter-angle type lock-blade
*
- Fixation of the file/drill
- Couple the counter-angle on the micromotor.
- Turn the lever counterclockwise (fig.08).
- Introduce the drill on the orifice and turn untill it locks on the limiter (fig.09).
- By touching the limiter with the drill, turn the lever to the initial direction to lock the drill (fig.10).
12
13
11
Counter-Angle Push Button type
*
- Fixation of the file/drill
- Couple the counter-angle on the micromotor.
- In the PB (Push Button) system, place the drill on
the guide and turn it until it locks inside the limiter
(fig.11). Afterwards press the head button and
displace the drill until it reaches the bottom of the
limiter, releasing the head button (fig.12).
- Make sure that the drill is placed until the bottom
for a deep fixation (fig.13).
OBS: Use only good quality and standardized drills.
Drills with a too long shaft can produce excessive
vibration lowering the lifespan of the bearings.
07
Connecting and disconnecting the counter-angle
Connecting
The counter-angle can be connected in 6 adjustable head positions. Align the positioning pins (A)
of the counter-angle with the positioning indentations (B) of the handpiece and introduce the head
until you listen a click (see fig.07).
Disconnecting
When removing the counter-angle, pull it
rectilinearly (fig.07).
a
b
Attention
Before connecting or disconnecting the
counter angle, turn off the motor. Check
if the counter-angles is well placed on
the handpiece.
*
Optional items
INSTALLATION OF EQUIPMENT
