Sabo 43-A ECONOMY, Руководство оператора

Страница: 62 / 106

10
GB
Only start the engine when standing behind of the mower.
Place the mower on a level surface where the grass is not too high (high grass inhibits the start of the cutter bar and makes
starting more difficult). Where this is not possible, position the mower in such a way that the cutter is facing diagonally away
from the user, although only as far as absolutely necessary.
– Push and hold the safety control bar (1) on the top tube (2) D .
– Slowly pull the starter cable (3) until resistance is felt, then rapidly pull it out E – the engine begins to run, slowly recoil
the cable.
The engine runs with optimum power at maximum speed, which is required for a clean cutting pattern (engine speed = blade
speed).
CAUTION
Hold the starter cable handle firmly when starting. The handle may otherwise slip out of your hand. Risk of injury!
IMPORTANT
The motor only operates when the safety control bracket is pressed against the upper part of the handlebar. As
soon as the safety control bracket is released, this returns to its original position under spring force, the motor
brake is actuated, and the motor and blade come to stop within three seconds.
10 SWITCHING OFF THE ENGINE (Illustration F )
– Release the safety control bracket (1) F .
11 EMERGENCY STOPPING
ATTENTION
Avoid injury! Engine and blade must stop within 3 seconds. If not, please contact the nearest authorized dealer.
Release the safety control lever and the drive switch bar.
– The mower will stop.
– The blade will stop.
– The engine will stop.
12 MOVEMENT DRIVE
Operating the rear wheel drive (Illustration G )
The rear wheel drive is switched on and off using the drive switch bar (1) on the upper handle (2) when the engine is running:
– Press drive switch bar and hold = mower runs.
– Release drive switch bar = mower stops (0 position).
13 GRASS COLLECTOR
Safety instruction!
See table for explanation of symbols page 3
Operation with grass collector
During mowing ensure that the collector is emptied in good time. The grass collector will only collect grass perfectly if it is
permeable to air.
IMPORTANT
Do not clean the grass collector with hot water!
IMPORTANT
Make sure that the chute (1) R1 is not bent when handling the collector.
Emptying the grass collector (Illustration L )
– Switch off engine.
– Lift ejection flap.
– Unhinge the full grass collector from the mower at the carrying strap – the ejection flap closes automatically.
– Empty the collector thoroughly whilst holding it by the carrying strap and the moulded handle on the bottom.