Sabo 43-A ECONOMY, Руководство оператора

Страница: 60 / 106

8
GB
• Never remove the spark plug connector when the motor is running! Risk: Electric shock.
• If the tank has to be emptied, this should be done in the open, and with a cold engine. Take care to ensure that no fuel
is spilt.
For warranty and safety reasons, original replacement parts must be used at all times.
6 DESCRIPTION OF COMPONENTS
1 Safety control bracket for the engine brake
2 Drive switch bar
3 Oil filling nozzle with dipstick
4 Cutting height adjuster
5 Spark plug
6 Air filter
7 Tank cap
8 Ejection flap
9 Starter cable grip
7 PREPARATION
The following parts are included in the packaging for assembly of the mower:
• Mower with preassembled handle
• Collecting bag, collecting bag frame
• Tool bag with the following contents:
– Operator's manual with Declaration of Conformity
– Warranty conditions and Warranty card
– Various fixing parts.
In the unlikely event of a missing part, please contact your dealer.
Opening out the handle (Illustration A1 + E1 + B1 )
– Pull the folded-up Z-shaped guide spar apart and upward A1 .
– When upper and lower handle are aligned tighten the two wing-nuts by hand E1 .
– Push both ends of the bottom part of the handle with the toothed plastic adapters backwards until they click into the
toothed recess on the mower housing B1 .
In this way, three different handle heights can be set.
– Tighten the two wing-nuts on both sides by hand B1 .
– Insert the cables on the left and right hand side into the cable guide. This is to prevent the cables from being trapped
when folding the handle E1 .
– Attach the Bowden cables to the bottom section of the guide spar with the aid of cable ties from the tool bag.
CAUTION
When you activate the bar height adjustment, when loosening the wing nuts B1 used to secure the bar bottom to
the housing (only loosen sufficiently to ensure that the bar can be moved freely) and snapping the toothed plastic
adaptations from the cut-out on the housing, it is possible that unintentional upsetting of the bar may occur. In
addition, this may result in crushed points between the bar bottom and the housing. This may result in a risk of
injury!
Handle starter assembly (Illustration D + L1 )
– The safety control bracket (1) on the upper handle (2) must be folded down before the starter cable can be suspended.
– Pull out the starter cable (3) slowly and fit in the starter handle mount (4) with a twist motion.
Attaching the grass collector to the mower (Illustration R1 + S1 )
– First insert the grass bag frame with the clip forward into the grass bag. Align the upper seams of the bag with the clip.
– Press the retaining profiles of the collecting sack onto the bars of the collecting sack frame R1 .
– Open the ejection flap of the mower upwards.
– Pick up the collecting sack by the carrying strap, place the chute (1) R1 at the collecting sack opening into the ejection
flap and hang it in the mower casing with its two side hooks upwards S1 .
– Attach ejection flap to collector.