Sabo 38-BV, Руководство оператора

Страница: 59 / 98

11
GB
Attaching the grass collector to the scarifier (Illustration L2 + S1 )
– Open the ejection flap of the scarifier upwards.
CAUTION
The exhaust gets very hot. If touched it can cause serious burns.
Always hold the ejection flap on the right when opening L2 !
– Pick up the collecting sack by the carrying strap and hang it in the scarifier casing with its two side hooks upwards S1 .
– Attach ejection flap to collector.
When using the machine, ensure that the collector is emptied in good time. The grass collector will only collect grass properly
if air can pass through it freely. If the cutter is set too low the grass collection is impaired.
IMPORTANT
Do not clean the grass collector with hot water!
Emptying the grass collector
– Switch of the motor and wait until the cutters come to a stop.
– Lift the ejection flap.
CAUTION
The exhaust gets very hot. If touched it can cause serious burns.
Always hold the ejection flap on the right when opening L2 !
– Remove the full grass bag from the scarifier by the carrying strap – the ejection flap closes automatically.
– Shake out of the grass bag thoroughly, holding it by the carrying strap and the moulded handle on the bottom.
Operation without grass collector
WARNING
When scarifying without grass collector the ejection flap on the scarifier housing must always be closed (flap
down).
14 SCARIFIER OPERATION
Safety instruction!
See table for explanation of symbols page 3
Using the machine on slopes
NOTE
The equipment can be driven on banks and slopes at an angle of up to 25°.
For safety reasons, however, we urgently recommend you not to exploit this theoretical performance potential.
Always make sure you have a firm stance. Manually guided scarifiers should never be used for slopes of more than
15°. Stability may be lost!
Checking the oil level
Check the oil level every time before using the scarifier Y1 . Never let the engine run with not enough or too much oil.
Irreparable damages could occur.
Checking operating safety
Before every scarifying job, make sure that the safety control bar is working perfectly. The motor must switch off when the
control handle is released, and the cutting tool must come to a standstill. Caution! The cutting tool runs on for a while!
Make sure that all protective devices have been attached properly and are not damaged!
To avoid danger, check the condition and tight fit of the cutter blades before every scarifying job (refer to the chapter “Cutter
blade shaft care” for more details). Always have work on the cutter blade shaft done by a specialist workshop. If the cutter
blade shaft is assembled incorrectly parts can become loose, which can lead to serious injuries.
Also check screws and nuts for a firm fit every 10 operating hours and tighten if necessary!
Make sure the spark plug connector is fitted tightly. Contact is only dangerous if the plug connector has not been installed
correctly. Never pull the plug connector off with the engine running! Danger: electric shock.
If the cutter blade shaft becomes blocked e.g. by colliding with an obstacle or through foreign objects, have an authorised
workshop check whether any parts of the scarifier are damaged or deformed. Always have any necessary repairs done by an
authorised workshop too.
Time restrictions
The time at which scarifiers may be used varies from region to region. Please ask the relevant authorities before using your scarifier.