5.3. USE WITH A POWERED MIXER.
With a powered mixer, the GRAPHI-Q must be inserted between the “Line Out” jack(s) (line level output,
before the signal goes through the amplifier) and the “Amplifier In” jack(s), as shown below:
NOTE: Not all powered mixers will offer such patch points, or they may label them differently. When
in doubt consult the manual of the console manufacturer.
5.4. USE AT A MIXER INSERT POINT.
The GRAPHI-Q may also be used at a mixer insert point, either for a single input channel, or for a group
or bus insert point. This will dedicate all of the features and processing power of the GRAPHI-Q to one
or two single channels on your mixer, or to a subgroup of inputs (for example, all the drums in your mix).
The patching will look like this:
5.5. SINGLE CHANNEL GRAPHI-Q: ONE INPUT TWO OUTPUTS.
The single channel GRAPHI-Q also offers a unique setup option, since it offers two parallel outputs.
Using the GRAPHI-Q software, it is possible to separately assign the settings for graphic EQ filters, FBX/
parametric filters, high/low pass filters, compressor/limiter, and digital delay to either or both outputs.
Compressor/limiter and all EQ adjustments will be the same for each output, but the digital delay and
output level settings may be set individually for the two outputs. The diagram on the following page shows
a possible one-input-into-two-outputs setup.
Section Five: Installation
