K-ROTOLIFT RF + AUTOLID
28
Setting favorite position and rotation angles
26.
Movement accuracy:
Please note that, due to many external reasons the accuracy of rotation
might be within the tolerance of 2°-3° for left/right movement and 1°-2° for central “0” setting.
Thus it is recommended taking this into consideration when designing the furniture and leaving
enough free space inside your furniture.
Using the programmed remote control, you can set the maximum ranges of motion:
a. Press & hold
SETUP button
for about 2 seconds
–
red SETUP led
will be lit and
you will hear 2 short "beep" signals. You are in SETUP mode.
b. Press the
UP button
to set the position. Press the
UP button
again to stop the lift. If
you do not stop the lift with UP button, it will automatically stops at the highest
position when it reaches the up limit switch
c. Press
RC-SET button (
You will hear intermittent beeper signal) and press the
UP
button
. You will see this symbol on the display . The up position has been set.
NOTE:
In
Rotolift with Autolid system the DOWN VP is permanently set in the lowest possible
position.
d. Use the
assigned buttons
on the remote to rotate the lift to your preferred left / right
position
e. press the
RC-SET button
on the controller or the programmed IR remote control.
You will hear a beep to indicate that the device is waiting for the expected function to
be entered
f.
press the button corresponding to LEFT OR RIGHT movement on your RF or IR
remote. For M1 (clockwise) this symbol will appear:
For M2 (counter-clockwise)
this symbol will appear:
NOTE:
You can pick any angle to set those parameters to. For example, you can rotate the lift to
around 30° left and set M1, then move it to 100° left and set M2 position.
g. After you are done with all the settings, simply leave the SETUP mode by pressing &
holding the
SETUP button
for about 2 seconds, until the red SETUP LED light will
go off. The preferred positions are now set and the controller is in normal operation
mode.
27.
Reset settings:
It is possible to reset all the favorite positions. To reset the lift press & hold
SETUP button for about 5 seconds. Control box will confirm resetting by short "beep" signal
and showing you this symbol on the digital display: After resetting the lift, it will move
substantially slower until it will reach the marginal positions, to calibrate itself.
NOTE:
If you reset the settings, please drive the lift to its lowest position, move it up and rotate at
least 45° left and 45° right. Skipping this step may result in the lift tilting.
