Assembly and operating manual
rtv.sabaj.pl/en/home/
a.
Press & hold
SETUP button
for about 2 seconds
–
red SETUP led
will be lit.
b.
Press
RC-SET (Memory) button
once - you will hear constant short beep signals.
Then press
SETUP button
– beep signal will stop. You will see this symbol on the
display: The control box is now awaiting IR signals.
c.
Aiming your remote towards the IR-Receiver, press
5 buttons
you want to use for
controlling the lift. Every properly received button will be confirmed by short pauses.
Number of pauses correspond to the button set:
(I) -
UP
(1 beep)
(II) -
DOWN
(2 beeps)
(III)
–
clockwise
(3 beeps)
(IV)
–
counter-clockwise
(4 beeps)
(V) -
RC-SET (Memory button / Power Guard activation button)
(5 beeps)
d. Press & hold
SETUP button
for about 2 seconds until the
red SETUP led
is off. The
controller is now in normal operation mode.
NOTE:
The programmed buttons of the remote control will be active at the same time for the
device operated by this remote control (fig. 20 - example settings). The lift can be operated by
more than one remote control. The preferred ranges of motion will be the same for all pilots.
fig. 20
