Runco XtremeProjection X-200i, Руководство по установке и эксплуатации

Страница: 74 / 118

Operation
58 Runco X-200i Series Installation/Operation Manual
PRE
L
IMINAR
Y
3D Control: Select 3D Control from the Main Menu to set the following options related to
formatting and delivery of HDMI 3D content.
• 3D Mode: Select 3D Mode from the 3D Control menu to specify how the X-200i
processes the “left eye” and “right eye” image components.
• Choose Auto to have the X-200i determine the appropriate 3D or 2D mode based
on the HDMI vendor-specific InfoFrame data. This is the default setting.
• Choose Off to watch all content, including that mastered in 3D, in 2D.
• Choose S ide-by- S ide to have the
projector scale the left and right image
halves respectively to fill the screen.
Side-by-Side multiplexing is used with
1080i source material.
• Choose Top-and-Bottom to have the
projector scale the top and bottom image
halves respectively to fill the screen.
Top-and-Bottom multiplexing is used with
720p or 1080p source material.
• Enable DLP Link: Set Enable DLP Link to On if you wish to use DLP Link 3D glasses
with this projector. The default setting is Off .
• L-R S wap: Choose L-R Swap from the 3D Control menu and set it to Reverse to
reverse the left- and right-eye image components, for content that was mastered
backwards.
• Dark Time: This control adjusts the amount of dark time between displayed frames for
3D content. Higher settings provide more time for shutters in the 3D glasses to open
and close, ensuring that each eye sees the full image intended for it. The available
settings are 1.0, 1.5, 2 or 2.5 milliseconds. The default setting is 1.0 ms.
• S ync Delay: This control adjusts the output 3D emitter delay to match the active
glasses to the left/right frames of the projector. Proper adjustment of this delay will
eliminate crosstalk and odd colors caused by timing differences between the glasses
and the projected image.
In order to use this feature, you must set the 1080p24 Output
setting (see below) to 96Hz.
When 1080p24 Output (see below) is set to 144Hz, the available
Dark Time settings are 1.0 or 1.5ms.
Use the system keypad on the projector to adjust this setting, so as
not to disrupt communication between the Active 3D Emitter and
the 3D glasses.
Note
Note
Tip