Runco XtremeProjection X-200i, Руководство по установке и эксплуатации

Страница: 60 / 118

Installation
44 Runco X-200i Series Installation/Operation Manual
PRE
L
IMINAR
Y
Yaw Adjust: Loosen the Yaw/X-Adjustment Levers to allow the lens to pivot freely from
side to side. Then, angle the lens to even out any left-to-right pincushion distortion:
Once the proper lens angle has been set, firmly tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Geometry:
1. Unscrew the Anamorphic Lens just enough to allow it to rotate freely.
2. Grasp the lens by the center ring and rotate the lens until the image is properly
anamorphic:
3. When the image geometry appears correct, tighten the
Anamorphic Lens Set Screw (
3 ) to secure the lens in place. (When
viewed from the front, the rear opening on the anamorphic lens
should appear as a tall, narrow oval.)
Focus: Finally, rotate the Focus Ring on the anamorphic
lens to fine-tune the optical focus.
Anamorphic Len s (Top View)
Wrong Position Correct Position
F
O
C
U
S