Runco XtremeProjection X-200i, Руководство по установке и эксплуатации

Страница: 45 / 118

Installation
Runco X-200i Series Installation/Operation Manual 29
PRE
L
IMINAR
Y
3.6
Connections to the
X -200i
Proceed as follows to connect the X-200i to your video sources, external controller(s) – if
present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don’t use a 20-foot cable when a
6-foot cable will suffice.)
• Route all cables through the opening at the bottom of the projector.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connector Panel Access To access the connector panel,
open the rear door by grasping the
handle and pulling it down and
toward you.
Route cables
through this
opening