Ruijie RSR10 Series, Руководство по установке оборудования

Страница: 93 / 104

Installation Manual Chapter 4 Starting and Configuring Router
4-1
4
Starting and Configuring Router
4.1 Starting Router
4.1.1 Setting Up the Configuration
Environment
When you use the router for the very first time, you will need to configure the router through
a console port as follows:
Step 1
Connect the serial port of a character terminal or PC to the Console port of the
network output engine through the standard RS232 cable and the Console.
Set up the local configuration environment through the Console port.
Step 2
Configure the communication setting parameters of the terminal. If a PC is
used, you must run the terminal simulation program, for example, Windows
HyperTerminal. The following describes the procedure with the
HyperTerminal as example. Run the HyperTerminal software to set up a new
connection. Select the serial port to connect the Console port of the network
output engine. Set the communication parameters: 9600 for baud rate, 8 data
bits, 1 stop bit, no parity check, and no flow control. In addition, select VT100
as the simulation terminal type.
When you have finished building the configuration environment, you may power on the
router.
4.1.2 Powering on Router
4.1.2.1
Check before Power-on
Before powering on the router, please check
 If the power cable and the grounding cable are connected correctly.
 If the power supply voltage meets the requirement.
 Whether the cable connection is correct and the PC or terminal for configuration has
been started and set up.
Warning
Before powering on the router, check the position of the power switch so that
you may cut power supply in time in case of accident.