Ruijie RSR10 Series, Руководство по установке оборудования

Страница: 91 / 104

Installation Manual Chapter 3 Installing Router
3-7
Step 2
Place the router in such a way that its rear panel faces you. Remove the blank
panel with screwdrivers.
Step 3
Flush the line card interface board and the edge of the opening of the back
panel of the router base.
Step 4
Push the line card to the router until the interface board closely touches the
backplane of the router.
Step 5
Tighten the fastening screws on the line card.
Step 6 Repeat steps 3 through 5 until all the line cards have been installed.
Warning
Before installing line card, mark sure all power supply connected to the router
is switched off. Otherwise, electric shock or device damage may occur.
Caution
At step 3 and step 4, please operate gently. The line card should be inserted
gently and smoothly. If you find it is difficult to push the line card, do not use
too strong force. Instead, unplug the line card and check if the SIC card
interface board has been aligned with the edge of the opening on the rear
panel at the base of the router before you can continue. Otherwise, the line
card may be damaged.
3.5.2 Removing Line Cards
Step 1 Switch off the router.
Step 2 Place the router in such a way that its rear panel faces you.
Step 3 Unplug the cables of the ports on the module you want to remove.
Step 4
Remove the fastening screws on the two sides of the line card interface board
with a straight screwdriver.
Step 5
Draw the line card to the front of you until the interface board completely
disengages from the base of the router.
Step 6 Repeat steps 4 and 5 until all line card interface boards have been removed.