Ruckus Wireless ZoneFlex 7762-S, Руководство по установке

Страница: 18 / 70

12
Before You Begin
Become Familiar with the Installation Components
360º Coverage of Deployment Area
If your deployment scenario requires wireless coverage in all directions, you can deploy
three colocated 7762-S APs and mount them on the same pole or mast in such as way that
together they provide 360 degrees of coverage.
Figure 9 illustrates how three 120-degree sector antennas (that are built into the 7762-S
APs) provide 360-degree coverage. These three sector antennas provide higher gain than
a single omnidirectional antenna can offer while having a broad vertical radiation angle.
Figure 9. Three colocated 7762-S APs provide 360-degree coverage
NOTE: If you are deploying colocated APs to provide a 360-degree area of coverage,
make sure you read “Connecting Colocated 7762-S Access Points” on page 14 .
Become Familiar with the Installation Components
The Access Point can be installed in an indoor or outdoor environment, such as an interior
wall or ceiling or on the exterior roof overhang of a building or on a streetlight pole. Refer
to
Figure 10 for the components involved in a typical installation.
Take note of the components that must be installed indoors or outdoors. The PoE injector
and power adapter that are shipped with the Access Point are for indoor use only. Ruckus
Wireless also strongly recommends that you form a drip loop on any cable that is
connected to devices that are installed outdoors under the Access Point. It is also a good
idea to include a drip loop at the entry point going through a wall.
120º coverage
120º coverage
120º coverage