VC-400RT
+
Managed VDSL2 CPE Router MANUAL Ver. A5
63
Notes:
1. Static Routing functionality is used to define the connected Gateway between the
LAN and WAN.
For example,
if we want to activate the Network Time Protocol (NTP) service, and we have to define the
Gateway connected
to NTP server in the WAN.
2. The gateway of static routing just used for switch(Bridged) mode.
When you click the
IPV6
tab in the Static Routing page, a screen is displayed as shown in Figure
4.8.1.1 The addition and deletion of static IPv6 routes is not supported currently.
Figure 4.8.1.1 Static Routing IPv6
Tip:
Please note that default route should not be added from this web page. To configure default route,
specify default Gateway on selected WAN in
WAN Setting
page.
4.8.2 RIP Support
The RIP support for enabling dynamic routes in CPE may be present in some of pre-built packages.
To enable the RIP support, click the
RIP Support
link (
Route > RIP Support
) on the left navigation
bar. A screen is displayed as shown in Figure 4.8.2.
Figure 4.8.2 Dynamic Routing