VC-400RT
+
Managed VDSL2 CPE Router MANUAL Ver. A5
10
Notes:
1.
Be sure each twisted-pair cable (RJ-45 ethernet cable) does not exceed 100
meters (333 feet).
2.
We advise using Category 5~7 UTP/STP cables for Cable bridge or Router
connections to avoid any confusion or inconvenience in the future when you
attached to high bandwidth devices.
3.
RJ-11 (VDSL2 Line port) use
24 ~ 26
gauge with twisted pair phone wiring,
we do not recommend 28 gauge or above.
4.
Be sure phone wire has been installed before VC-400RT+ powered on.
2.6 VDSL2 Application
The router’s line port supports 100Mbps/0.3km for data service across existing phone wiring. It is
easy-to-use which do not require installation of additional wiring. Every modular phone jack in the
home can become a port on the LAN. Networking devices can be installed on a single telephone
wire that can installation within suitable distance (depends on speed) (Figure 2.2)
Figure 2.2
VC-400RT+ application
2.6.1 Connect the VC-400LT and the VC-400RT+ to the Line
The objective for VDSL2 is to pass high speed data over a twisted pair cable. In the setup,
connect VC-400LT to VC-400RT+ through phone wire(24~26 AWG) or line simulator or any
other hardware representation of a cable network, with or without noise injection and crosstalk
simulations.