
VC-400RT
+
Managed VDSL2 CPE Router MANUAL Ver. A5
99
Appendix C: Router Mode select
This appendix describes how to select the router mode, The VC-400RT+ default mode is
switch(bridged mode), please refer to the following steps to select the router mode or switch mode.
Select the Router mode:
1. To configure the router mode settings, click the
LAN Settings
link (
LAN > LAN Settings
) on the
left navigation bar. Then select the “Server" at the DHCP Mode, and click Apply at any time during
configuration to save the information that you have entered. A screen is displayed as shown in
Figure C.1
Figure C-1 DHCP Mode – Server
Note:
Please refer to the section 4.7.2 to configure the DHCP Server settings.
2.
Click the
WAN Setting
link (
WAN Setting > WAN
) on the left navigation bar to specify the WAN
setting. Please cancel the check of the Auto Detect Enable, and Add to config the wan type.
Figure C-2 WAN Setting
3.
Please refer to the
section 4.5.6
to config the wan type, the user can configure the Dynamic IP
Address, Static IP Address, PPPoE mode.