rtd CMV6486DX100HR, Руководство пользователя

Страница: 86 / 118

86
• On the cpuModule or another computer, format a floppy disk and copy onto it the
files you wish to copy to the SSD. If you wish to boot from the SSD, you must
format with the '/s' switch to copy system files. See your DOS manual for details
of the format command.
• Apply power to the cpuModule.
• If using +12V Flash, connect programming voltage, Vpp, of 12Vdc (+/- 5%) to pin
10 of the Multifunction connector.
• Set jumper JP1 and/or JP2 to the required position to provide programming voltage
(Vpp) to the Flash EPROMs. Please see page SSD Jumpers on page 102.
• Run the SSD program on the cpuModule. Perform the menu selections appropriate
for the chosen memory devices, then start programming.
• When programming is complete, remove programming voltage by re-positioning
jumpers JP1 and/or JP2.
After re-booting, the Solid State Disk will be seen by the system as a write-protected floppy. DOS
commands normally used to read floppy disks will work with the SSD.
Installing a Conventional SSD using SRAM or NOVRAM
When the Solid State Disk is composed of SRAMs or NOVRAMs, it appears as a read/write disk
and may be read and written using normal DOS disk commands.
To install an SRAM or NOVRAM SSD, you should follow this procedure:
• Apply power to the cpuModule and run Setup.
• If you are using the device in socket U1, set SSD Device in U1 to the appropriate
device type.
• If you are using the device in socket U2, set SSD Device in U2 to the appropriate
device type.
• Set SSD Window to a value which will not conflict with other hardware or software.
• Save your changes and exit Setup.
• Turn off the cpuModule.
• Set jumpers JP1 and JP7 or JP2 and JP8 to the appropriate settings. Please see page
SSD Jumpers on page 102.
• Install the memory devices into the correct cpuModule sockets.
• Reboot the cpuModule. The SSD should appear as the next available drive in your
system.
• Format the SSD using the DOS format command.
NOTE! Start with a blank, newly-formatted disk each time you transfer files.
You must copy files to the disk only one time, and must not delete,
re-copy, or rename files on the floppy disk. If the files become
fragmented, the process will not work!
NOTE! The memory window selected for DOC must not be used by any other
program or hardware device. Make sure this window is not in use by
EMM386 or another memory manager, or an SSD, Ethernet card,
PCMCIA card, etc.