RSP STC350, Руководство по эксплуатации продукта

Страница: 31 / 48

M0605-1 ver 2.5 31
3.6 Hints
3.5.1 Programming
The following will ensure a correct docking position.
Action
1 Attach a spare tool attachment to the swivel with tool changer.
2 Position a spare tool attachment above the tool attachment that is mounted on the
tool.
3 The right position is found when the tool attachments are parallel, centered and
engraved arrows are on the same line.
4 Save the position. The robot can move to this position with high speed.
5 Dismount the spare tool attachment.
6 Go back to the saved position and move the swivel with tool changer (in the
direction of axis 6) the remaining distance to the tool attachment (mounted on the
tool).
7 Save the position. The robot should move to this position with low speed.
3.5.2 Electrical installation
Connection kits for the tool changer and tool attachment are available (see
section 2.2.5).
3.5.3 Tool stand
NOTE! To guarantee reliability and a long service-life for the tool changer, the tool
stand must be stable, both in terms of its design and attachment.
NOTE!
The tool stand must not be spring-loaded!
See section 2.2.3 for suitable tool stand equipment.
3.5.4 Tool Identification
Jumpers on signals at the tool attachment can be used to give information about
which tool attachment that is docked in the tool changer.
3.5.5 Arm load parameters
Swivel and tools are adding load to the robot and rotational friction and torque to
axis 6. If the load and torque force are not stated during programming it may
affect the behaviour and wear of the robot and robot peripherals.