RS SAILING RS Quest, Руководство по монтажу

Страница: 33 / 86

31
Feed one end of the main halyard into the track on
the back of the mast through the opening above the
gooseneck joint.
Feed the main halyard the whole way up the mast,
through the masthead fitting, around the turning block
and back down the mast.
6.5 - Main Halyard
Shackle the 30mm block for the jib halyard to the second
lowest eye on the front of the mast (below where the
shrouds and forestay join the mast).
6.6 - Jib Halyard
Tie off both ends of the main halyard at the bottom of the mast so that they are
easily accessible once the mast is stepped in the boat.
Add the plastic bobble on the end of the
rope.
Add the plastic bobble to one end of the jib halyard
then pass the other end through the block and back
down the mast.
Top tip: It is much easier to thread the halyard up the
mast if you put a small screwdriver or needle in through
the track and into the rope to pull the end upwards.
a)
b)
c)
a)
b)