Roxell HaiKoo, Инструкция по использованию и сборке

Страница: 77 / 90

ROXELL - 009 - 3509 HAIKOO -- INSTALLATION INSTRUCTIONS
III--27
FIGURE 68. FIGURE 69.
Fix the auger to the drive shaft of the gearhead with the
drive block.
Clamp the auger under
the drive block.
Put the thin edge towards the
gearbox.
Slide the auger slowly back into the tube.
Feed intake boot.
M
Pull the auger until it stretches, then let it relax. Mark the
auger at the edge of the feed intake boot.
FIGURE 70. FIGURE 71.
Tighten the 4 bolts with a hex wrench.
ALWAYS SEE THAT THE AUGER CANNOT SPRING BACK (BY USING CLAMPS) WHEN YOU
PUT IT UNDER TENSION.
Stretch the auger
1,7cm per 3m tube.
Measure the
required stretch from Mark
M
to the feed intake boot. Here
you put a new mark
NM
Slide the anchor into the auger until the auger touches the
anchor end.
FIGURE 72. FIGURE 73.
Now put a pliers past this mark
NM
Let the auger slide
back into the tube until the pliers rest against the feed
intake boot.
Firmly tighten the set screw in the middle of the anchor, so
it will expand and clamp the auger.
Cut the auger with a hacksaw or grinding
machine.
NM
M