Roxell HaiKoo, Инструкция по использованию и сборке

Страница: 59 / 90

ROXELL - 009 - 2111 HAIKOO -- INSTALLATION INSTRUCTIONS
III--9
SUSPENSION FOR FEEDER LINE
SUSPEND THE CONTROL UNIT AT LEAST 3M FROM THE HOUSE END WALL !
PROCEDURE :
-- First determine the position of the feeder lines.
-- Then measure the distance from the wall to the first feeder line.
-- Mark from this spot the suspension points on the ceiling over the whole length of the line.
Central winch
Alternatives : see page III--7
Fix the suspension points
(well aligned !)
every 3 m. Hook openings
point away from the central winch.
FIGURE 13.
MAKE SURE THAT THE MAIN CABLE 5mm DOES NOT HANG IN, BUT BESIDE THE SCREW HOOKS
AND PULLEYS !
Hang a SMALL PULLEY on each SCREW HOOK.
Slide a piece of suspension cord through each pulley (towards the central winch)
Fix this cord at 15 cm from the pulley to the main cable 5 mm with a cable clamp.
CABLE CLAMP
MAIN CABLE
CENTRAL
WINCH
FIGURE 14.
Make a loop around the tube.
Push the end of the cord in the needle opening.
Pull the needle through the cord.
Respect these measurements !
Remove the needle.
MAIN CABLE BESIDE SCREW
HOOKS AND PULLEYS !
FIGURE 15.
Start suspending from the central winch. Proceed to both ends until the whole feeder line is suspended.
Determine the length of cord to be cut as follows :
-- add 55cm.
CUT BY MEANS OF A SOLDERING IRON OR AN ELECTRICALLY HEATED KNIFE.
REMARK : AFTER INSTALLATION OF THE PANS, WHEN THE LINE HANGS LEVEL, YOU CAN INSERT
THE CORD END BACK INTO THE CORD. THIS ADDS TO THE HEIGHT THE LINE CAN BE RAISED AND
ALLOWS A NEATER FINISH.