Roxell HaiKoo, Инструкция по использованию и сборке

Страница: 56 / 90

HAIKOO -- INSTALLATION INSTRUCTIONS ROXELL - 009 - 2111
III--6
3x240V
3x200V
N
N
3x220V
(IEC38--N)
(IEC38--3x230V)
ELECTRICITY .... WATCH OUT !
LEAVE CONNECTIONS TO THE SYSTEM TO A QUALIFIED ELECTRICIAN !
-- Wire the system with the utmost care and attention.
-- Always provide a solid earthing.
-- Check all connections before you switch on.
-- Always follow the wiring diagrams included in the control panels.
-- Compare setting of the thermic protection with the data on the motor label. Thermic protections are set at minimum by
the manufacturer.
-- If you do not use a Roxell control panel, make sure to provide the necessary thermic protections.
-- Compare motor label plate and motor connection with local voltage :
ELECTRICAL WIRING DIAGRAM
SEALED PARTS IN CONTROL PANELS MUST UNDER NO CONDITION WHATSOEVER BE
UNSEALED !
ONLY THE CONNECTION DIAGRAM IS SHOWN IN THE ASSEMBLY GUIDE. WIRING DIAGRAMS ARE
ALWAYS SUPPLIED WITH THE CONTROL PANELS.
FIGURE 1.
FA II
FA I
1
2
2
9
3
3
4
5
6
(N / N
(N IEC 38
3x200V / 3x220V
3x230V IEC 38
/ 3x240V).
Control pan
7
Cut--off switch
8
7
3
8
8
1.
Supply cable(4x2,5+2,5).
2.
Cable Flex--Auger power units(3x2,5+2,5).
3.
Cable drive units (3x2,5+2,5).
4.
Cable max. sensor weigherCable max. sensor weigher(4x1,5)+ safety switch FA II
(2x1,5).
5.
Cable impulse switch weigher (2x0,75+0,75).
6.
Cable safety switch Flex--Auger I (2x1,5)
7.
Cableswitch control unit(2x1,5).
8.
Cable min. switch hopper(2x1,5)+ safety switch
9.
Cable max.sensor Flex-Auger(4x1,5).
10.
Cable min. sensor weigher (4x1,5).
10
Central control panel
Weigher
Drive unit
Bin